|
|
|
|
|
|
Reader: v2.2
Release: April of 2011
Features:
- new body construction
- improved connectors strength
Adapter legs - screw DIN 965 M2.5õ12 À2
Adapter legs - nut DIN 439 M2.5 À2
Adapter to body - nut DIN 934 M2.5 À2
Body - screw DIN 965 M2.5õ10 À2
Body - nut DIN 934 M2.5 À2
Reader: v2.1
Release: May of 2008
Disadvantages: when overloaded effort is used with tightening of screw during replacement of adapter (1) it is possible to get the deformation with bend of the adapter card and loss of contact in the middle of contact socket (2). Upon repetitive efforts made for mounting the adapter, it is possible deformation of the main board with deflection inside which leads to separation solder legs of chip CY7C68001 (located below on the main board). The appearance of the defect is expressed in multiple glitches in the work of the reader, hanging when reading, a lot of errors in read dumps. This defect can be eliminated with soldering of contacts of legs chips.
Recommendation: Do not use over force to install / remove the adapter, when attaching the adapter to the reader!
Reader: v2.0
Release: May of 2007
There were the radical design changes.
Velocity of reading was improved up to 512mb per 40 seconds.
Disadvantages: when overloaded effort is used with tightening of screw during replacement of adapter (1) then separation takes place of solder pin on the main board reader (2). Damage is eliminated with soldering of pins.
Recommendation: Do not use force while changing adapter to secure the reader!
Reader v1.0
Release: September of 2005
It was the first serial reader. Reading speed was up to 256 mb per hour.
|
|
|
|
|
|
|
|
|
|
