Flash Extractor
Soft-Center
About     Shop     Downloads     Manual     Library     Forum     Services     Contacts
External power
Attention: This article is for people who understand what they do. You can damage reader and memory chip with wrong actions!

Adapter modification

Find two pin connector and jumper



Drill holes for it in pcb (d=1mm)
Remove trace between holes



Remove varnish from traces by sides



Put connector in holes
And bend his legs



Solder legs to traces
Attention: Do not put solder on gold adapter contacts. You can lost your adapter at this step



To use reader power, put jumper on connector
To use external power, remove jumper





Using external power

Solder power wires to capacitor
3.3V is near white line on capacitor



Remove jumper
Attach adapter to external power source



Memory chip supply current usualy about 10mA (0.01A) or less
If current is much bigger, immediately turn power off

Attention: Safe voltage range for reader is 2.4 .. 3.3V

Last added
SD_61   2c a4 64 32   2x1 SM2236G AC   2c 68 01 a6   4x2   v3 CBM2098S   2c 68 04 4b   1x1 PS2251-07-V   ec de 88 bf   1x1 Monolith Micro SD_2   45 3c a9 a2   1x1 SM3267L AB   98 3a a8 92   1x2 Monolith_USB_32   ec d7 98 ca   1x1 IT1167FN-46B   89 88 24 4b   1x1 Monolith Micro SD_1   2c 68 04 4a   1x2 Monolith SD_1   45 3e 97 93   1x1   v2
News
07.10.2016 Conatiner v9
07.09.2016 VT / Auto - new mode
27.07.2016 CR2 files support
10.04.2016 Processor Cores
08.03.2016 Sandisk Rotate
Other products
Soft-Center ltd.