Flash Extractor
Soft-Center
About     Shop     Downloads     Manual     Library     Forum     Services     Contacts
Data recovery
1. Write numbers on chips
2. Read dumps
3. Start Flash_Extractor
4. Open dumps
5. Choose model

Good model criterion is 90% green ECC map
If there is no correct model, send dumps to tech support

6. Switch ECC mode to "On"
7. Open assembler with model actions execute
8. Open or save disk image

Good model criterion is 90% circles near file names is green
Don't count grey

If something is wrong:
- Check conflicts
- Return to mix editor and try change dump order
Last added
AU6989NHL-2   98 d7 98 b2   1x1 SM3281L-AB   45 3c 98 b3   1x1   v5 Monolith Micro SD_76   98 3c 99 a3   1x4 SM3265P-AC   45 3e 98 03   1x1 SM3281N-AB   45 48 9a b3   2x2 Monolith Micro SD_75   32 2c c3 08   1x1 Monolith Micro SD_74   45 3e 98 b3   1x4   Ref AU6989SNHL-2   45 de 98 92   1x1 SM3261L-AB   45 de 98 92   1x1 SM2232T AC   89 d7 94 3e   4x2
News
23.09.2022 The End
11.11.2021 Legs for NR
16.08.2021 Sector Number Slow
15.07.2021 New drivers
21.05.2021 BGA-152 18x12 (smaller)
Other products
Soft-Center ltd.