[pcimage]

Struggling with this one, did the last UP10 controller OK.

2 Dumps (only one bank found in each chip)

Find FAT16 in 1st dump @ 0x179f4000
Find 00 ...02 ...04 ...06... in FAT of 1st dump, in consecutive sectors

Find 01 ...03 ...05 ... 07 in same place in 2nd dump, consecutive again

So, I think join by 528, right?

Block size I find to be 0x108000

Use Block Number 1001 with Marker 514/515 and get..

Show Blocks
-----------
Bank 00
0x0000 - 0x03f3 = 1012
Bank 01
0x0000 - 0x03bb = 956
Bank 02
0x0000 - 0x0000 = 1 <<< look here
0x029e - 0x029e = 1

Find Bank Space
---------------
Bank 01 Start 0x03ff Size 0x3ff -> 0x400 OK

Find Bank Size
--------------
00 / 0x000 / 0x3f3
01 / 0x000 / 0x3bb

Make disk.image, but not folders/data

I'm going to try and upload the 1.dump and 2.dump to the container, see if you can tell me where I've gone wrong.

Thanks

[Сергей]

MBR, FAT, FAT1, FAT2 green or red?

Root on place?

[pcimage]

MBR and FAT are green, but folders are complete garbage.

Raw scan find nothing good, some headers but no real data.

[Сергей]

Put in container log of Check_Dirs

[pcimage]

I will do that tomorrow, I'm at home right now.

I did think that Bank 2 looked wrong, but could work out how to get it right?

Although this is a 2Gb drive, there appears to be very little data.

In fact, both 1Gb dumps were able to be RAR'd and put into the container.

[Сергей]

Additional steps
Split by Block 0x84000
Join by Block 4224

[pcimage]